Floor Wax, Floor Finish Stripper – Pour N Peel Floor Stripper

Description

Floor Stripper – Pour N’ Peel is a high power, high speed floor stripper was developed to penetrate and remove multiple coats of burnished floor finish with a minimum of labor. Utilizing the latest in technology, this powerful professional stripper actually “unlocks” the chemical bonds of acrylic and urethane fortified floor finishes.

May be used as a no scrub floor stripper or with a conventional floor machine and pad depending on the condition of the floor. Can be sprayed on cove moldings to soften and remove accumulations of old finishes and wax.

• Fast Penetration of build up finishes and sealer layers
• Powerful and fast acting
• Removes multiple layers of finish to get the job done in fewer passes
• Variable dilution rate to match the job
• Works in cool water
• Parish-Supply.com – The janitorial supply company customers trust.

Pour N Peel Stripper removes water based concrete sealers from resilient tile, Terrazzo, Flagstone, Vinyl, Ceramic Tile, Asphalt Tile (test first) Rubber (test first) Linoleum, Vinyl Asbestos, Sealed Wood, and Concrete floors.

Packaging

Pour N’ Peel is packaged in one gallon containers sold each or by the case of 4

Videos:

Specifications:

Pour N’ Peel Floor Stripper Specifications

Active Ingredients: 50%

Color: Clear

Odor: Sassafras

pH: 13.0 – 13.5

Viscosity: Water thin

Ammonia Content: None

Foam: Low

Phosphate Content: None

Solubility: Complete with water

Emulsification: Excellent

Detergency: Excellent

Rinsability: Excellent

Flash Point: 145 F (TCC)

Biodegradability: Complete

Storage / Stability: 2 years

Freeze / Thaw stability: Keep from freezing

More Info:

Directions:

The desired concentration will depend on the build-up and age of the polish film. As a starting point dilute with cold water as follows:

On average, 1 gallon of Pour N’ Peel floor stripper diluted at 1:4 will cover approximately 500 square feet.

• For Average Build-Up: Dilute 1 to 4 with cold water.
• For Moderate Build-Up: Dilute 1 to 3 with cold water.
• For Heavy Aged Build-Up: Dilute 1 to 2 with cold water.
• For Use With A Floor Machine: Dilute 1 to 8-16 parts cold water.

Mop a generous solution onto the floor to be stripped. Allow solution to stand about 5 minutes keeping the floor wet at all times. If mop stripping – agitate with the mop. If using an automatic scrubber or rotary floor machine, no mop agitation is required. Pick up the solution with a wet vacuum, automatic scrubber or clean mop. Allow floor to dry thoroughly prior to applying any sealer or finish. If desired, a rinsing step can be added.

*NOTE: Asphalt tile (usually the old 9″ x 9″) and Rubber, LVT or Vinyl flooring could be affected by stripping solutions in high concentrations. Always test floor before proceeding If in doubt use pH Neutral Stripper.