Compare

• Increases the slip resistance on finished floors
• Economical to use - highly concentrated
• The Best floor restorer on the entire planet!
• A long time favorite in our company since 1999

• Simply mix 1-2 ounces in a 32 ounce spray bottle and burnish away your problems.

Interim Maintenance:

Supplies You Will Need:

• A clean mop bucket and wringer
• A clean, wet mop
• An ultra high-speed floor machine (1500 rpm or more)
• Floor pads: Select from Natural Fiber, PT-3000 or Eraser floor pad

Packaging

More Info:

• Top Guard Frequently Asked Questions

Directions:

• Clean bucket and wringer.
• Wet mop - Rayon or Floor finish mops both work well (these mops will leave more product on the floor)
• High-speed floor machine (burnisher) 1500 -2000 rpm
• Floor pads: Select from any of the light-medium aggressive Natural Blend Hair pads.

• Fill Mop bucket with 1 gallon of cold water. (If unsure of amount, use an empty gallon container to help measure.)
• Squeeze Top Guard bottle to fill the chamber with two (2) ounces of Top Guard and pour into bucket.

• Squeeze Top Guard bottle to fill the chamber with one (1) ounce of Top Guard and pour into spray bottle. Fill spray bottle to top with cold water.

• Damp Mopping: Wring out the mop well. Top Guard should be applied to the floor a bit thinner than a coat of floor finish.
• Spray Bottle: Slowly swing your arm from side to side spraying Top Guard from the bottle in a stream (not a spray). Do not worry about applying Top Guard evenly, the floor pad will spread the solution evenly over the floor when burnishing.

Burnishing Instructions

Top Guard can be burnished Wet or Dry! When Damp Mopped, allow approximately 1 minute for Top Guard to begin to dry and burnish while still damp for best results. When applied via spray bottle, begin burnishing immediately after Top Guard has been applied to the floor. *Take your time when burnishing for the first few times for a stronger, deeper shine.

Things to Look for While Using Top Guard

Top Guard enhances the slip coefficient of the floor. Walk on the floor while it is wet and take note of how non-slip the floor appears. When dry, test the slip resistance of the floor ...... Incredible. Make special note of the gloss. It's deep and water clear, not hazy like polymer based restorers. Top Guard is the only Finish Enhancement product that eliminates the dust created from burnishing (even with propane). Remember to look at the bottom of the floor pad. There's no white ring, no build-up. The finish that's on the floor stays on the floor.