Compare

Replacement brass clips allow the user to adjust the tension on the rubber blade within the channel to ensure the perfect edge on the glass. The Ettore brass clips are a handy tool for holding the squeegee rubber in place. These clips conveniently fit all Ettore regular body channels and standard size squeegee channels.

• Works with any Ettore window squeegee and Backflip tool
• Clips can be used on brass, stainless, and aluminum channels
• Sold each or by the dozen

Directions:

The squeegee blade is held in place by two clips on each end of the squeegee channel. With your fingers (or small pliers if necessary), pull the blade out and remove the clip. Go to the other side of the squeegee channel and slide the blade out of the channel. When installing a new blade, install the clip on one end about 1/8 of an inch from the end and slide the new blade in. Pull the blade on the other end and stretch the rubber enough to put the clip on the other side, again about 1/8th of an inch from the end. Push the rubber and clip into the channel, and it is installed.

Easy Paks Detergent / Disinfectant has a concentrated powdered compound that quickly dissolves in water to produce a cleaning disinfectant dilution to meet your needs. Cleans, deodorizes, and disinfects hard, nonporous surfaces. Effective against bacteria and viruses including HIV-1 (AIDS virus) and controls mildew. Ideal for use in food service, nursing homes, and other settings where housekeeping and disinfection are important.

Effective

• Effective against bacteria and viruses, including HIV-1 (AIDS virus), and controls mildew
• Pre-measured packets make it easy to use

Versatile

• Ideal for use in nursing homes and other settings where housekeeping and disinfection are important
• Use on inanimate, hard, nonporous surfaces such as walls, floors, sink tops, tables, and chairs
• The handy storage tub saves space and weighs less than 3 pounds
• Each tub is labeled in English, French, and Spanish to reduce training time and make instructions easily understandable

Directions:

Follow label dilution instructions by dropping packet directly into water. Do not remove packets before use. Store in a cool, dry place. Do not handle packets with wet hands.

• For heavily soiled areas, a pre-cleaning step is required.
• To disinfect inanimate, hard, nonporous surfaces, add one pre-measured packet of product (1/2 ounce per 1 gallon of warm water). Stir gently to form a uniform solution.
• Apply solution with a mop, cloth, sponge, or hand pump trigger sprayer so as to wet all surfaces thoroughly.
• Allow to remain wet for 10 minutes and then let air dry.
• Prepare a fresh solution for each use.

Mildewstat

• To control mold and mildew on pre-cleaned, hard, nonporous surfaces mix this product at the stated dilution rate for disinfection.
• Apply solution with a mop, cloth, sponge, or hand pump trigger sprayer making sure to wet all surfaces completely. Let air dry.
• Prepare a fresh solution for each use.
• Repeat application at weekly intervals or when mildew growth appears.
• At the disinfectant dilution rate, this product is also fungicidal against the pathogenic fungi, Trichophyton mentagrophytes.