Compare

Replacement brass clips allow the user to adjust the tension on the rubber blade within the channel to ensure the perfect edge on the glass. The Ettore brass clips are a handy tool for holding the squeegee rubber in place. These clips conveniently fit all Ettore regular body channels and standard size squeegee channels.

• Works with any Ettore window squeegee and Backflip tool
• Clips can be used on brass, stainless, and aluminum channels
• Sold each or by the dozen

Directions:

The squeegee blade is held in place by two clips on each end of the squeegee channel. With your fingers (or small pliers if necessary), pull the blade out and remove the clip. Go to the other side of the squeegee channel and slide the blade out of the channel. When installing a new blade, install the clip on one end about 1/8 of an inch from the end and slide the new blade in. Pull the blade on the other end and stretch the rubber enough to put the clip on the other side, again about 1/8th of an inch from the end. Push the rubber and clip into the channel, and it is installed.