Compare

400 grit Twister Heavy Duty Red pads are for heavy-duty cleaning and scratch removal of worn terrazzo and stone floors. Twister HD Red will effectively remove scratches and stains from the surface and leaves a clean, matte surface prepared for the subsequent Twister steps.

• Pads are impregnated with billions of microscopic diamonds instead of traditional abrasives.
• Natural fiber material (hog hair).
• Longer lasting than conventional Twister Red pads.
• Twister HD Red is a problem solver for natural stone or concrete floors that have been etched or stained.
• Assists in removing scratches in Terrazzo & Concrete floor surfaces.
• On heavily guarded, coated or finished floors, TXP can be used to deep scrub or strip the floors prior to re-coating. 

Twister HD Red is a non-woven pad made from recycled PET blend with natural hair impregnated with microscopic diamonds bound in resin. Diamond abrasive applied on one side of the pad. Thickness of the pad is approximately one inch.

Twister HD Red Pads are Available in Sizes:

• 13, 14, 16, 17, 20, 24, 27 inch 

Packaging

Twister HD Red pads are packaged 2 pads per case.

Videos:

Specifications:

• Twister Floor Pad Brochure (pdf)

• Twister Floor Pad Handbook (pdf)

Twister HD Red Diamond Pads

Brand: Twister 

Color: Red (single sided)

Abrasive Content: 400 grit

Sizes: 13 in. - 27 in.

Thickness: 1 in.

Fiber: Natural fiber (hog hair)

Tensile Strength: 65 lbs.

More Info:

Average Life Expectancy

Under normal conditions (according to the manufacturer) the Twister Red (400 grit) pad will last between 15,000 - 12,000 square feet before it's time to replace it. In a real world application the actual life is more along the lines of 4,000 - 6,000 square feet.

This is factoring in making 4-6 passes over the floor in order to perform the proper surface in preparation for the next step.

Directions:

Maintenance of the Twister Pad:

Twister HD Red (400 grit) pad is designed for use with an automatic scrubber or standard speed floor machine with an operating speed between 150 -350 rpm. Do not use a high-speed burnisher with the Twister HD Red pad.

1. Remove pad from machine after each use.

2. Rinse the pad thoroughly with water. This removes dirt that can wear on the floor and your Twister Pad.

• On day 30, the fan will stop and the red LED light will blink.
• If the cover is not changed by day 33 a discreet alert will sound.

• Mango Refill #EF12MG

Packaging

Videos:

Specifications:

More Info:

• Green blinking LED – Good (first 30 days)
• Red flashing LED – Replace Cover. (After 30 days)
• Audible alert, discretely notifies service needed every 3 ½ minutes. (after 33rd day).
• No light - Needs battery & cover

Directions:

1. Install top mounting anchor and screw in wall
2. Hang dispenser on wall and mark through screw hole with a pencil
3. Remove dispenser, drill hole and insert anchor
4. Rehang dispenser on top screw, align with the side screw hole and insert screw to secure dispenser to the wall

1. Clean wall surface
2. Remove protective cover from tape, apply dispenser to wall
3. Press firmly
4. Install cover

1. Insert "C" size alkaline battery. Make sure the fan turns for 10 seconds and the green LED light blinks
2. Hang cover on top mounting tab, then pull down over bottom mounting tab
3. After 30 days, push up firmly on lower release tab to loosen cover. Remove spent cover. The red and green LED lights will both blink to reset the program.
4. Repeat step 2 to install a new cover.